User Manual

User Manual of Network Traffic Speed Dome
© Hikvision
74
IPv6 Subnet Mask, IPv4 or IPv6 Default Gateway, MTU [1280~1500] settings and Multicast
Address.
4. (Optional) Check the Enable Multicast Discovery checkbox, and then the online network
camera can be automatically detected by client software via private multicast protocol in the
LAN.
Figure 7-2 DNS Server Settings
5. Click Save to save the above settings.
You can click Test to make sure that the IP address is valid.
Configuring DDNS Settings
Purpose:
If your speed dome is set to use PPPoE as its default network connection, you can use the
Dynamic DNS (DDNS) for network access.
Before you start:
Registration on the DDNS server is required before configuring the DDNS settings of the speed
dome.
 For your privacy and to better protect your system against security risks, we strongly
recommend the use of strong passwords for all functions and network devices. The password
should be something of your own choosing (using a minimum of 8 characters, including
upper case letters, lower case letters, numbers and special characters) in order to increase
the security of your product.
 Proper configuration of all passwords and other security settings is the responsibility of the
installer and/or end-user.
Steps:
1. Enter the DDNS settings interface:
Configuration > Network > Basic Settings > DDNS
2. Check Enable DDNS to enable this feature.
3. Select DDNS Type. Two DDNS types are selectable: DynDNS, and NO-IP.
 DynDNS:
Steps:
(1) Enter Server Address of DynDNS (e.g. members.dyndns.org).
(2) In the Domain text field, enter the domain name obtained from the DynDNS website.
(3) Enter the Port of DynDNS server.
(4) Enter the User Name and Password registered on the DynDNS website.
(5) Click Save to save the settings.