User Manual
Table Of Contents
- Chapter 1 Overview
- Chapter 2 Network Connection
- Chapter 3 Accessing to the Network Speed Dome
- Chapter 4 Basic Operations
- Chapter 5 ITS Configuration
- 5.1 Set Enforcement
- 5.2 Set Vehicle Detection
- 5.3 Set Basic Configuration
- 5.4 Set Advanced Parameters
- 5.5 Pictures
- 5.6 Set FTP Host
- 5.7 Set Blocklist & Allowlist
- Chapter 6 Speed Dome Configuration
- 6.1 Storage Settings
- 6.2 Basic Event Configuration
- 6.3 Smart Event Configuration
- 6.4 PTZ Configuration
- 6.4.1 Configuring Basic PTZ Parameters
- 6.4.2 Configuring PTZ Limits
- 6.4.3 Configuring Initial Position
- 6.4.4 Configuring Park Actions
- 6.4.5 Configuring Privacy Mask
- 6.4.6 Configuring Scheduled Tasks
- 6.4.7 Clearing PTZ Configurations
- 6.4.8 Prioritize PTZ
- 6.4.9 Configuring Position Settings
- 6.4.10 Configuring Rapid Focus
- Chapter 7 System Configuration
- 7.1 Configuring Network Settings
- 7.2 Configuring Video and Audio Settings
- 7.3 Configuring Image Settings
- 7.4 Configuring System Settings
- Appendix
User Manual of Network Traffic Speed Dome
© Hikvision
70
6.4.8 Prioritize PTZ
Steps:
1. Enter the Prioritize PTZ interface:
Configuration > PTZ > Prioritize PTZ
Figure 6-32 Position Settings
2. Select Network or RS-485 from the drop-down list
3. Set the delay time.
4. Click Save to save the settings.
6.4.9 Configuring Position Settings
Purpose:
You can set the position information in this interface, including the position information of the
device. The display format of position can be configured in Configuration > PTZ > Basic Settings.
Steps:
1. Enter the Position Settings interface:
Configuration > PTZ > Position Settings
Figure 6-33 Position Settings
2. Manually find the north position for the speed dome in Live View interface, and click Set at
North to set the north direction.
3. After the speed dome changes its direction, you can click Point to North and the speed dome
turns back to the north direction.
4. You can manually set GPS information including longitude and latitude.