User Manual

User Manual of Network Traffic Speed Dome
© Hikvision
58
3. Click Arming Schedule to enter the arming schedule setting interface. The arming schedule
configuration is the same as the setting of the arming schedule for motion detection. Refer
to section 6.2.1 Configuring Motion Detection.
4. Click Linkage Method to select the linkage method taken for tampering, notify surveillance
center, send email and trigger alarm output are selectable. Refer to section 6.2.1
Configuring Motion Detection.
5. Click Save to save the settings.
6.2.3 Configuring Alarm Input
Steps:
1. Enter the Alarm Input settings interface:
Configuration > Event > Basic Event > Alarm Input
2. Choose the alarm input No. and the Alarm Type. The alarm type can be NO (Normally Open)
and NC (Normally Closed).
3. Edit the name in to set a name for the
alarm input (optional).
Figure 6-17 Alarm Input Settings
4. Click Arming Schedule to enter the arming schedule setting interface. The arming schedule
configuration is the same as the setting of the arming schedule for motion detection. Refer
to section 6.2.1 Configuring Motion Detection.
5. Click Linkage Method to select the linkage method taken for tampering, notify surveillance
center, send email and trigger alarm output are selectable. Refer to section 6.2.1
Configuring Motion Detection.
6. You can also choose the PTZ linking for the alarm input. Check the relative checkbox and
select the No. to enable Preset Calling, Patrol Calling or Pattern Calling.
7. You can copy your settings to other alarm inputs.
8. Click Save to save the settings.