User Manual

User Manual of Network Traffic Speed Dome
© Hikvision
52
Storage Management > Net HDD
Figure 6-9 Select Net HDD Type
2. Enter the IP address and the file path of the network disk.
3. Select the mounting type. NFS and SMB/CIFS are selectable. You can set the user name and
password to guarantee the security if SMB/CIFS is selected.
4. If the status of the disk is Uninitialized, check the corresponding checkbox to select the disk
and click Format to start initializing the disk.
Note:
Refer to the NAS User Manual for creating the file path.
 For your privacy and to better protect your system against security risks, we strongly
recommend the use of strong passwords for all functions and network devices. The
password should be something of your own choosing (using a minimum of 8 characters,
including upper case letters, lower case letters, numbers and special characters) in order
to increase the security of your product.
 Proper configuration of all passwords and other security settings is the responsibility of
the installer and/or end-user.
5. Click Save to add the network disk.
Note:
After having saved successfully, you need to reboot the speed dome to activate the settings.
6.2 Basic Event Configuration
Purpose:
This section explains how to configure the network speed dome to respond to alarm events,
including motion detection, video tampering, alarm input, alarm output, and exception. These
events can trigger the alarm actions, such as Send Email, Notify Surveillance Center, etc.
For example, when motion detection is triggered, the network speed dome sends a notification
to an e-mail address.
Notes:
 On the event configuration page, click to show the PTZ control panel or click to hide it.
 Click the direction buttons to control the pan/tilt movements.