User Manual
Table Of Contents
- Chapter 1 Overview
- Chapter 2 Network Connection
- Chapter 3 Accessing to the Network Speed Dome
- Chapter 4 Basic Operations
- Chapter 5 ITS Configuration
- 5.1 Set Enforcement
- 5.2 Set Vehicle Detection
- 5.3 Set Basic Configuration
- 5.4 Set Advanced Parameters
- 5.5 Pictures
- 5.6 Set FTP Host
- 5.7 Set Blocklist & Allowlist
- Chapter 6 Speed Dome Configuration
- 6.1 Storage Settings
- 6.2 Basic Event Configuration
- 6.3 Smart Event Configuration
- 6.4 PTZ Configuration
- 6.4.1 Configuring Basic PTZ Parameters
- 6.4.2 Configuring PTZ Limits
- 6.4.3 Configuring Initial Position
- 6.4.4 Configuring Park Actions
- 6.4.5 Configuring Privacy Mask
- 6.4.6 Configuring Scheduled Tasks
- 6.4.7 Clearing PTZ Configurations
- 6.4.8 Prioritize PTZ
- 6.4.9 Configuring Position Settings
- 6.4.10 Configuring Rapid Focus
- Chapter 7 System Configuration
- 7.1 Configuring Network Settings
- 7.2 Configuring Video and Audio Settings
- 7.3 Configuring Image Settings
- 7.4 Configuring System Settings
- Appendix
User Manual of Network Traffic Speed Dome
© Hikvision
108
device can find the firmware in the directory automatically.
3. Click Browse to select the local upgrade file and then click Upgrade to start remote upgrade.
Note:
The upgrading process will take 1 to 10 minutes. Please don't disconnect power of the speed
dome during the process. The speed dome reboots automatically after upgrading.
Figure 7-53 Remote Upgrade
Log Searching
Purpose:
The operation, alarm, exception and information of the speed dome can be stored in log files. You
can also export the log files on your demand.
Before you start:
Please configure network storage for the speed dome or insert a memory card in the speed
dome.
Steps:
1. Enter the Log interface:
Configuration >System > Maintenance > Log
Figure 7-54 Log Searching Interface
2. Set the log search conditions to specify the search, including the Major Type, Minor Type,
Start Time and End Time as shown in Figure 7-54.
3. Click Search to search log files. The matched log files will be displayed on the Log interface.