iDS-2CD7AxxG0-IZH(Y) Network Bullet Camera Quick Start Guide
© 2021 Hangzhou Hikvision Digital Technology Co., Ltd. All rights reserved. About this Manual The Manual includes instructions for using and managing the Product. Pictures, charts, images and all other information hereinafter are for description and explanation only. The information contained in the Manual is subject to change, without notice, due to firmware updates or other reasons. Please find the latest version of this Manual at the Hikvision website (http://www.hikvision.com).
Regulatory Information FCC Information Please take attention that changes or modification not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. FCC Compliance: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Industry Canada ICES-003 Compliance This device meets the CAN ICES-3 (B)/NMB-3(B) standards requirements. Cautions and Warnings These instructions are intended to ensure that the user can use the product correctly to avoid danger or property loss. Laws and Regulations The device should be used in compliance with local laws, electrical safety regulations, and fire prevention regulations. Transportation Keep the device in original or similar packaging while transporting it.
DO NOT expose the device to high electromagnetic radiation or dusty environments. For indoor-only device, place it in a dry and well-ventilated environment. DO NOT aim the lens at the sun or any other bright light. Make sure the running environment meets the requirement of the device. The operating temperature shall be -30° to 65° C (-22° to 149° F), -H model: -40° to 65° C (-40° to 149° F), and the operating humidity shall be 95% or less (non-condensing).
Table of Contents Symbols and Marks ........................................................................................................................................... 7 Installation........................................................................................................................................................ 8 1.1* ..................................................................................................................................................................
Symbols and Marks Notice Warning Forbidden Correct Incorrect Turn to page A and continue MicroSD i. Not necessarily included accessory ii. Variable accessory amount iii.
Installation 2x 1x 1x T20 T10 1x 1x 1x 1x
1.
1.
2.
A.1 A.
A.3 A.4 5.
B.1 B.2 6.
B.3 B.
2.
2.
2.
2.5 2.6 2.
2.
2.
2.
2.
2.10 3.
3.
3.
3.
3.
3.
4.
Operation Activate and Access Network Camera Scan the QR code to get Activate and Access Camera. Note that mobile data charges may apply if Wi-Fi is unavailable. Reset and Restore Camera Press Reset button for about 10s when the camera is powering on or rebooting to restore the default settings, including the user name, password, IP address, port no., etc. For the position of the reset button, refer to the figure on page 2.
