User Manual

iDS-2CD7xxG0-xxxxx Network Bullet Camera User Manual
UM iDS-2CD7xxG0-xxxxx 021021NA 49
8. Click Save.
Set Region Entrance Detection
Use to detect objects entering a pre-defined virtual region. If it occurs, the device can take linkage
actions.
Steps
1. Go to Configuration → Event → Smart Event → Region Entrance Detection.
2. Check Enable.
3. Select one Region. For the region settings, refer to Draw Area.
4. Select the detection target. Human and Vehicle are available. If the detection target is not selected, all
detected targets will be reported, including humans and vehicles.
Figure 6-6 Set Rule
5. Optional: You can set the parameters of multiple areas by repeating the above steps.
6. For the arming schedule settings, refer to Set Arming Schedule. For the linkage method settings, refer
to Linkage Method Settings.
7. Click Save.
Set Region Exiting Detection
Detects objects exiting from a pre-defined virtual region. If it occurs, the device can take linkage actions.
Steps
1. Go to Configuration → Event → Smart Event → Region Exiting Detection.
2. Check Enable.
3. Select one Region. For the detection region settings, refer to Draw Area.