User Manual

iDS-2CD7xxG0-xxxxx Network Bullet Camera User Manual
UM iDS-2CD7xxG0-xxxxx 021021NA 44
Steps
1. Go to Configuration → Event → Basic Event → Video Quality Diagnosis.
2. Select Diagnosis Type.
3. Set the corresponding parameters.
• Alarm Detection Interval: The time interval to detect the exception.
• Sensitivity: The higher the value is, the more easily the exception will be detected, and the higher
possibility of misinformation would be.
• Alarm Delay Times: The device uploads the alarm when the alarm reaches the set number of times.
4. Check Enable, and the selected diagnosis type will be detected.
5. Set arming schedule. See Set Arming Schedule.
6. Set linkage method. See Linkage Method Settings.
7. Click Save.
The function is supported only by certain models. The actual display varies with models.
Set Vibration Detection
It is used to detect whether the device is vibrating. The device reports an alarm and triggers linkage
actions if the function is enabled.
Steps
1. Go to Configuration → Event → Basic Event → Vibration Detection.
2. Check Enable.
3. Drag the slider to set the detection sensitivity. You can also enter number to set the sensitivity.
4. Set the arming schedule. See Set Arming Schedule.
5. Set the linkage method. See Linkage Method Settings.
6. Click Save.
The function is supported only by certain models. The actual display varies by model.
Smart Event
For certain device models, you need to enable the smart event function on VCA Resource
page first to show the function configuration page.
The function varies by model.