User Manual

iDS-2CD7xxG0-xxxxx Network Bullet Camera User Manual
UM iDS-2CD7xxG0-xxxxx 021021NA 35
Steps
1. Go to Configuration → Storage → Schedule Settings → Record Schedule.
2. Check Enable.
3. Select a record type.
The record types vary by model.
• Continuous: The video will be recorded continuously according to the schedule.
• Motion: When motion detection is enabled and trigger recording is selected as linkage method,
object movement is recorded.
• Alarm: When alarm input is enabled and trigger recording is selected as linkage method, the video is
recorded after receiving alarm signal from external alarm input device.
• Motion | Alarm: Video is recorded when motion is detected or alarm signal is received from the
external alarm input device.
• Motion & Alarm: Video is recorded only when motion is detected and alarm signal is received from
the external alarm input device.
• Event: The video is recorded when configured event is detected.
4. Set schedule for the selected record type. Refer to Set Arming Schedule for the setting operation.
5. Click Advanced to set the advanced settings.
• Overwrite: Enable Overwrite to overwrite the video records when the storage space is full. Otherwise
the camera cannot record new videos.
• Pre-record: The time period you set to record before the scheduled time.
• Post-record: The time period you set to stop recording after the scheduled time.
• Stream Type: Select the stream type for recording.
When you select a stream type with a higher bitrate, the actual time of the pre-record and
post-record may be less than the set value.
• Recording Expiration: The recordings are deleted when they exceed the expired time. The expired
time is configurable. Note that once the recordings are deleted, they cannot be recovered.
6. Click Save.
Record Manually
Steps
1. Go to Configuration → Local.