Quick Start Guide

Network Dome Camera·Quick Start Guide
17
5. Adjust the view angle.
1). Loosen the three base screws with the supplied wrench to
remove the bubble.
2). Loosen the tilt adjusting screws.
3). Adjust the camera view angle in panning and tilting directions.
The angle range of the pan direction is 0° to 355°, and the
angle range of the tilt direction is 0° to 75°.
4). Tighten the tilt adjusting screws.
5). Tighten the base screws to replace the bubble.
Tilting
0° to 75°
Panning 0° to 355°
Tilt Adjusting
Screw
Pan Adjusting
Bracket
Figure 2-4 Adjust the View Angle
2.1.3 Ceiling Mounting with Bracket
Before you start:
The ceiling mounting bracket is not included in the package. You
need to purchase the ceiling mount bracket separately. Make sure
the Wi-Fi antenna has been installed before the ceiling mounting.