EPI-4225I-DE-Quick-start-Guide

QSG EPI-4225I-DE 030518NA 21
Figure 5-1 Verification Code Setting (SADP)
Note:
The verification code is required when adding the camera to Hik-Connect.
3. Click and read the “Terms of Service” and “Privacy Policy.”
4. Confirm the settings.
5.2.1 Enable Hik-Connect via a Web Browser
Before You Start:
Activate the camera before enabling the service. Refer to Chapter 3.2. for more
information.
Steps:
1. Access the camera via the Web browser. Refer to Chapter 4.
2. Enter the platform access configuration interface, as follows: Configuration >
Network > Advanced Settings > Platform Access.
Figure 5-2 Platform Access Configuration (Web)
3. Set the Platform Access Mode to Hik-Connect.