EPI-4225I-DE-Quick-start-Guide

QSG EPI-4225I-DE 030518NA 12
2.1.2 In-Ceiling Mounting
Note:
 The height of the space above the ceiling must be more than 250 mm.
 The thickness of the ceiling must range from 5 mm to 40 mm.
 The ceiling must be strong enough to withstand more than four times the weight of
the speed dome and the accessories.
Steps:
1. Install the memory card.
Note:
Refer to step 1 in Section 2.1.1 Wall Mounting.
2. Drill screw holes in the ceiling.
1) Attach the drill template to the ceiling where you want to install the speed
dome.
2) Cut a hole and drill screw holes according to the drill template.
Note:
±2 mm of the circle diameter is tolerable.
3. Route the cables through the ceiling for the speed dome.
4. Install the bracket on the speed dome.
1) Place the in-ceiling bracket on the speed dome according to the direction of the
arrow shown in Figure 2-7.
2) Rotate and tighten the screws on the bracket to fix the bracket with the speed
dome.
Figure 2-7 Install the Bracket