EPI-4225I-DE-Quick-start-Guide

QSG EPI-4225I-DE 030518NA 10
Figure 2-2 Memory Card Slot
3) Re-install the rear cover and tighten the lock screws.
2. Install the bracket.
1) Get the bracket and screws from the packing box as shown in Figure 2-3.
Figure 2-3 Wall Mounting Bracket
2) Drill four screw holes in the wall according to the holes on the bracket, and then
insert four M8 expansion screws into the mounting holes.
3) Attach the gasket and the bracket to the wall by aligning the four screw holes on
the bracket with four expansion screws on the wall.
4) Secure the bracket with four hex nuts and washers.
Figure 2-4 Secure the Bracket
3. Install the speed dome to the bracket.
1) Hook the two ends of the safety rope to the speed dome and the bracket
respectively as shown in Figure 2-5.