Quick Start Guide

ECT-B12Fx Quick Start Guide
QSG ECT-B12Fx 031518NA 3
for specific battery information. The battery is marked with this symbol, which may
include lettering to indicate cadmium (Cd), lead (Pb), or mercury (Hg). For proper
recycling, return the battery to your supplier or to a designated collection point. For more
information see: www.recyclethis.info.
Industry Canada ICES-003 Compliance
This device meets the CAN ICES-3 (A)/NMB-3(A) standards requirements.
Warning
This is a class A product. In a domestic environment this product may cause radio interference in
which case the user may be required to take adequate measures.
Safety Instruction
These instructions are intended to ensure that user can use the product correctly to avoid danger
or property loss.
The precaution measure is divided into “Warnings” and “Cautions”.
Warnings: Serious injury or death may occur if any of the warnings are neglected.
Cautions: Injury or equipment damage may occur if any of the cautions are neglected.
Warnings
• In the use of the device, you must be in strict compliance with the electrical safety regulations of
the nation and region.
• Input voltage should meet both the SELV (S afety Extra Low Voltage) and the Limited Power Source
with 12 VDC according to the IEC60950-1 standard. Refer to technical specifications for detailed
information.
• Do not connect multiple devices to one power adapter to avoid over-heating or a fire hazard
caused by overload.
• Make sure that the plug is firmly connected to the power socket.
• Make sure that the device is firmly fixed if wall mounting or ceiling mounting is adopted.
• If smoke, odor or noise rise from the device, turn off the power at once and unplug the power
cord, and then contact the service center.
• Never attempt to disassemble the camera by unprofessional personal.
Cautions
• Do not drop the camera or subject it to physical shock.
• Do not place the camera in extremely hot, cold (the operating temperature shall be -40°C to
60°C), dusty or damp locations, and do not expose it to high electromagnetic radiation.
• Do not touch senor modules with fingers.
• If cleaning is necessary, use clean cloth with a bit of ethanol and wipe it gently.
Warnings Follow these safeguards to
prevent serious injury or death.
Cautions Follow these precautions to
prevent potential injury or material damage.