ECI-T22F2-Quick-start-Guide

1 Appearance Description
This turret camera appearance is shown as the figures below.
1
2
3
5
4
Figure 1-1 Turret Camera Overview
Type Description Table 1-1
No. Description
1 Enclosure
2 Camera Body
3 Mounting Base
4 Power Cord
5 Network Cable
Note:
For cameras that support power over Ethernet (PoE), the power is passed along with data on
Ethernet cabling. A switch that supports the PoE function is required.
2 Installation
Make sure of the following before you start:
● The device included in the package is in good condition and all required parts are
included.
● The standard power supply is 12 VDC or PoE (802.3af), and must be consistent with
camera requirements.
● Equipment is powered-off during installation.
● The installation environment is correct.
● The wall is strong enough to withstand four times the weight of the camera and bracket.
● There are no reflective surfaces too close to the camera lens. The IR light from the
camera may reflect back into the lens and cause reflection.
Note:
Four camera types have the same installation method. We will use the III/IV turret camera as
an example to illustrate the installation.
Before you start: