Quick Start Guide

ECI-D64Z2 Network Dome Camera Quick Start Guide
QSG VE ECI-D64Z2 041118NA 7
● The wall is strong enough to withstand four times the weight of the camera and mount.
For IR cameras, take the following precautions in order to prevent IR reflection:
● Dust or grease on the dome cover will cause IR reflection. Please do not remove the
dome cover film until installation is complete. If there is dust or grease on the dome
cover, clean the dome cover with a soft cloth and isopropyl alcohol.
● Make sure that there is no reflective surface that is too close to the camera lens. The IR
light from the camera may reflect back into the lens, which may cause reflection.
● The foam ring around the lens must be seated flush against the inner surface of the
bubble, so as to isolate the lens from the IR LEDS. Fasten the dome cover to the camera
body, and ensure that the foam ring and dome cover are seamlessly attached.
Preparation 2.1
Before mounting, disassemble the camera and install the memory card.
2.1.1 Disassembly
Steps:
1. Loosen the three screws on the edge of the bubble with a screw driver.
2. Take off the bubble.
3. Remove the inner black liner.
Black Liner
Screws
Bubble
Remove the Bubble and Black Liner Figure 2-1
2.1.2 Memory Card Installation
Steps:
1. Rotate the camera body to completely expose the memory card slot.
2. Insert the memory card and push to mount.
Note:
A microSD memory card is not included with the camera and must be purchased separately.