Quick Start Guide

ECI-D64Z2 Network Dome Camera Quick Start Guide

QSG VE ECI-D64Z2 041118NA 3

Industry Canada ICES-003 Compliance

This device meets the CAN ICES-3 (B)/NMB-3(B) standards requirements.

Safety Instruction

These instructions are intended to ensure that user can use the product correctly to avoid

danger or property loss.

The precaution measure is divided into “Warnings” and “Cautions.”

Warnings: Serious injury or death may occur if any of the warnings are neglected.

Cautions: Injury or equipment damage may occur if any of the cautions are neglected.

Warnings

• Proper configuration of all passwords and other security settings is the responsibility of

the installer and/or end-user.

• In the use of the product, you must be in strict compliance with the electrical safety

regulations of the nation and region. Please refer to technical specifications for detailed

information.

• Input voltage should meet both the SELV (Safety Extra Low Voltage) and the Limited

Power Source with 12 VDC according to the IEC60950-1 standard. Please refer to

technical specifications for detailed information.

• Do not connect several devices to one power adapter as adapter overload may cause

over-heating or a fire hazard.

• Please make sure that the plug is firmly connected to the power socket. When the

product is mounted on wall or ceiling, the device shall be firmly fixed.

• If smoke, odor or noise rise from the device, turn off the power at once and unplug the

power cable, and then please contact the service center.

Cautions

• Make sure the power supply voltage is correct before using the camera.

• Do not drop the camera or subject it to physical shock.

• Do not touch sensor modules with fingers. If cleaning is necessary, use clean cloth with a

bit of ethanol and wipe it gently. If the camera will not be used for an extended period,

please replace the lens cap to protect the sensor from dirt.

• Do not aim the camera at the sun or extra bright locations. Blooming or smearing may

occur (which is not a malfunction), and affect the sensor endurance at the same time.