Quick Start Guide

ECI-D64Z2 Network Dome Camera Quick Start Guide
QSG VE ECI-D64Z2 041118NA 18
5.2.1 Enable Hik-Connect via a Web Browser
Before You Start:
Activate the camera before enabling the service. Refer to Chapter 3.2. for more information.
Steps:
5. Access the camera via the Web browser. Refer to Chapter 4.
6. Enter the platform access configuration interface, as follows: Configuration > Network >
Advanced Settings > Platform Access.
Platform Access Configuration (Web) Figure 5-2
7. Set the Platform Access Mode to Hik-Connect.
8. Check the Enable checkbox.
9. Click and read the “Terms of Service” and “Privacy Policy” in the pop-up window.
10. Create or change the verification code for the camera.
Note:
A verification code is required when you add the camera to Hik-Connect.
11. Save the settings.
Add Camera to Hik-Connect 5.3
Before You Start:
You need to enable Hik-Connect on the camera before adding it to your Hik-Connect
account. Refer to Chapter 5.1.
Steps:
1. Use a network cable to connect the camera to a router if the camera does not support
Wi-Fi.