Quick Start Guide
Network PTZ Camera·Quick Start Guide
32
Steps:
1. Attach the drill template (supplied) to the place where you want
to fix the PTZ camera, and make sure the front arrow appoints to
the monitoring area.
2. Drill a cable hole in the ceiling according to the circle A on the
template if you want to route the cables through the ceiling, as
shown in Figure 2-47.
Figure 2-47 Attach the Drill Template
3. Insert the expansion screws into the ceiling. (Optional)
4. Insert four PM4×10 screws into the ceiling and fix the base plate,
as shown in Figure 2-48. Make sure the FRONT arrow of the base
plate is of the same direction as the arrow of the drill template.