User Manual
Table Of Contents
- 1 Introduction
- 2 Installation
- 3 FAQ
- Question: The device is plugged in but the preview software (for example, AMCap 3.0.9) does not show preview image.
- Question: The device delivers 4K image in AMCap 3.0.9, but the actual frame rate cannot reach 30 fps in spite of setting the frame rate at 30 fps.
- Question: The device is plugged in but no audio out.
- Question: The device is plugged in but 3840 × 2160 resolution is unavailable, i.e. the device is unable to deliver 4K image.
- Question: The device is plugged in to the laptop, but the preview image is abnormal or cannot deliver 4K image.
When any laser equipment is in use, make sure that
the device lens is not exposed to the laser beam, or it
may burn out.
DO NOT aim the lens at the sun or any other bright
light.
To avoid heat accumulation, good ventilation is
required for a proper operating environment.
DO NOT expose the device to extremely hot, cold,
dusty, corrosive, saline-alkali, or damp environments.
For temperature and humidity requirements, see
device specification.
DO NOT expose the device to high electromagnetic
radiation.
If smoke, odor, or noise arises from the device,
immediately turn off the power, unplug the power
cable, and contact the service center.