User Manual
Table Of Contents
- 1 Introduction
- 2 Installation
- 3 FAQ
- Question: The device is plugged in but the preview software (for example, AMCap 3.0.9) does not show preview image.
- Question: The device delivers 4K image in AMCap 3.0.9, but the actual frame rate cannot reach 30 fps in spite of setting the frame rate at 30 fps.
- Question: The device is plugged in but no audio out.
- Question: The device is plugged in but 3840 × 2160 resolution is unavailable, i.e. the device is unable to deliver 4K image.
- Question: The device is plugged in to the laptop, but the preview image is abnormal or cannot deliver 4K image.
Warning
This is a class A product. In a domestic environment this
product may cause radio interference in which case the
user may be required to take adequate measures.
Safety Instruction
These instructions are intended to ensure that user can
use the product correctly to avoid danger or property
loss.
The precaution measure is divided into “Warnings” and
“Cautions”.
Warnings: Serious injury or death may occur if any of
the warnings are neglected.
Cautions: Injury or equipment damage may occur if any
of the cautions are neglected.
Warnings
The device should be used in compliance with local
laws, electrical safety regulations, and fire prevention
regulations.
The socket-outlet shall be installed near the
equipment and shall be easily accessible.
Cautions
The device will be charged by specified source which
the output circuit comply with LPS/PS 2.
No naked flame sources, such as lighted candles,
should be placed on the equipment.
Install the equipment according to the instructions in
this manual.
Never place the equipment in an unstable location.
The equipment may fall, causing serious personal
injury or death.
DO NOT touch the sharp edges or corners.
Keep the device in original or similar packaging while
transporting it.
DO NOT drop the product or subject it to physical
shock.
Refer to the device label for the standard power
supply. Please make sure your power supply matches
with your device.
Use a power adapter provided by qualified
manufacturers. It is recommended to provide an
independent power adapter for each device as
adapter overload may cause over-heating or a fire
hazard.
If the product does not work properly, please contact
your dealer or the nearest service center. We shall
not assume any responsibility for problems caused by
unauthorized repair or maintenance.
Please use a soft and dry cloth to clean the interior
and exterior surfaces. Do not use alkaline detergents.
Warnings Follow
these safeguards to
prevent serious injury
or death.
Cautions Follow these
precautions to prevent
potential injury or
material damage.