User Manual

83
Check the faults in the Enable Arming with Fault list, and the device will not stop the arming
procedure when faults occurred.
Fault Checklist
The system will check if the device has the faults in the checklist during the arming procedure.
Arm LED Stay On
If the device applies EN standard, by default, the function is disabled. In this case, if the device is
armed, the indicator will be solid blue for 5 s. And if the device is disarmed, the indicator will
flash 5 times.
When the function is enabled, if the device is armed, the indicator will be on all the time. And if
the device is disarmed, the indicator will be off.
Fault Prompt On Arming/Disarming
If the device applies EN standard, by default, the function is disabled. In this case, the device will
not prompt faults during the arming/disarming procedure.
Enable Early Alarm
If you enable the function, when the zone is armed and the zone is triggered, the alarm will be
triggered after the set delay time.
Note
The early alarm will be taken effect only after the delayed zone is triggered.
Device Enroll Mode
Click Enter the Enrollment Mode to make the panel enter the enroll mode.
Time Settings
You can set the device time zone, synchronize device time, and set the DST time. The device
supports time synchronization via Hik-Connect Guarding Vision server.
Time Management
Click System → System Settings → Time to enter the Time Management page.