User Manual

30
Wi-Fi Fault Check
If the option is enabled, when the Wi-Fi is disconnected or with other faults, the alarm will be
triggered.
Cellular Network Fault Check
If the option is enabled, when the cellular data network is disconnected or with other faults, the
alarm will be triggered.
AC Power Down Check Time
The system checks the fault after the configured time duration after AC power down.
To compliant the EN 50131-3, the check time duration should be 10 s.
System Instructions
In the site, tap the AX PRO and then log in to the device (if required). Tap → System → System
Options → System Instructions to enter the page.
Arm with Fault
If the option is enabled, when there is a fault during the arming procedure, you can stop arming
manually.
Checklist
The system will check if the device has the faults in the checklist during the arming procedure.
Arm with Fault Checklist
Check the faults in the Fault Check list, and the device will not stop the arming procedure when
faults occurred.
Arm LED Stay On
If the device applies EN standard, by default, the function is disabled. In this case, if the device is
armed, the LED will be solid blue for 5 s. And if the device is disarmed, the LED will flash 5 times.
When the function is enabled, if the device is armed, the LED will be on all the time. And if the
device is disarmed, the LED will be off.
Fault Prompts On Arming
If the device applies EN standard, by default, the function is disabled. In this case, the device will
not prompt faults during the arming procedure.
Fault Prompts On Disarming
If the device applies EN standard, by default, the function is disabled. In this case, the device will
not prompt faults during the disarming procedure.
Early Alarm
If you enable the function, when the zone is armed and the zone is triggered, the alarm will be
triggered after the delay time.
Early Alarm Time
When the early alarm function is enabled, you should set the early alarm time. The alarm will be