User Manual

29
Options → System Management to enter the page.
Forced Auto Arm
If the option is enabled and there are active faults in a zone, the zone will be bypassed
automatically.
System Status Report
Switch for uploading system reports.
Voice Prompt
If the option is enabled, the AX PRO will enable the text voice prompt.
Audible Tamper Alarm
If the option is enabled, the system will alert with buzzer for the tamper alarm.
If the option is disabled, peripherals will report lid opened, but not link to alarms.
System Volume
The available system volume range is from 0 to 10.
Panel Lockup Button
If the option is enabled, the installer can use the lockup button function to lock the AX PRO.
After locking, users can not operate the device and receive messages.
Panel Alarm Duration
Set the time duration of the panel alarms.
Polling Loss Times
Set the maximum duration for polling loss. The system will report fault if the duration is over
the limit.
Bypass on Re-Arm
The bypassed zone will back to arm if fault restored.
Fault Check
In the site, tap the AX PRO. Tap → System → System Options → Panel Fault Check to enter
the page.
Detect Network Camera Disconnection
If the option is enabled, when the linked network camera is disconnected, an alarm will be
triggered.
Battery Fault Check
If the option is enabled, when battery is disconnected or out of charge, the device will not
upload events.
LAN Fault Check
If the option is enabled, when the wired network is disconnected or with other faults, the alarm
will be triggered.