User Manual

Note

Only the administrator can do such an operation.

Edit Keypad

Password

If the target user is an administrator, an installer, or an operator, you

can tap the target user on the user list and then tap Edit Keypad

Password to set the keypad password to the target user.

Edit Duress Password

If the target user is an administrator or an operator, you can tap the

target user on the user list and then tap Edit Duress Password to set

the duress password to the target user.

Note

If under duress, you can enter the duress code on the keyboard to

arm and disarm area(s) and upload a duress alarm.

Automation Control

An administrator, an installer or an operator can control the relay

module, wall switch and smart plug.

Note

● Configuration items and user permission will vary according to the user type.

● You can view linked cards/tags and keyfobs of the user but you do not have permission to

configure them.

Card/Tag Management

After adding cards/tags to the wireless AX PRO, you can swipe the card/tag to arm or disarm all

the detectors added to specific area(s) of the AX PRO, and silence alarms.

Note

The tag ID/PIN is a 32 bit long integer, and the variant could be 42949672956.

Steps

1. Enter the site, tap the AX PRO and then log in to the device (if required) to enter the page.

2. Tap → User Management → Card/Tag to enter the Tag Management page.

3. Tap + to add a Tag.

4. When hearing the voice prompt "Swipe Tag", you should present the Tag on the AX PRO Tag

presenting area.

● When hearing a beep sound, the Tag is recognized.