User Manual
3
Enrollment
4
Installaon
2. Aach the front panel onto the rear panel.
Note: The addional force shall be equal to three mes the weight of the equipment but not less than 50N. The equipment
and its associated mounng means shall remain secure during the installaon. Aer the installaon, the equipment, including
any associated mounng plate, shall not be damaged.
1. Secure the rear panel on the wall with
four supplied screws.
3. Tighten the screw on the boom
to complete the installaon.
Enroll the Peripheral Locally
Enroll the Peripheral with QR Code or Serial No.
1. In the APP, tap the "Enrollment Mode" buon on the control panel page to make the control panel enter the enroll-
ment status.
2. Push the power switch of the peripheral to on, and it will be automacally enrolled to the control panel.
1. In the APP, tap the icon "+"and scan the QR code or enter the serial No. on the peripheral.
2. Push the power switch of the peripheral to on, and it will be automacally enrolled to the control panel.
1. Remove the screw on the boom of the keypad.
2. Disassemble the keypad and remove the rear panel.
3. Power on the security control panel.
4. Log in the APP and tap the icon "+" . Scan the QR code or input the control panel serial No. to add the control panel.
5. Enroll the peripheral locally, with OR code, or with serial No..
Remove the screw on the boom of the keypad.
Disassemble the keypad and remove the rear panel.
Scan the QR code on the rear panel of the keypad.
Push the power switch to ON.
Check signal strength and select installaon place
Enter the signal checking mode by operang on the control panel.
Connual green (3 s) and off (3 s): Strong
Connual green and red (3 s) and off (3 s): Medium
Connual Red (3 s) and off (3 s): Weak
Connual flashing red (3 s) and off (3 s): Lost
2
CAUTION
IF THE BATTERY COMPARTMENT
DOES NOT CLOSE SECURELY,
STOP USING THE PRODUCT AND
KEEP IT AWAY FROM CHILDREN.
Hangzhou Hikvision Digital Technology CO.,Ltd. No.555 Qianmo Road, Binjiang District, Hangzhou 310052, China