User Manual

11
Specificaon
10
Operaon Cauon and Device Maintenance
- All the electronic operaon should be strictly compliance with the electrical safety regulaons, fire prevenon regulaons and other related
regulaons in your local region.
- Do not drop the device or subject it to physical shock, and do not expose it to high electromagnesm radiaon. Avoid the equipment
installaon on vibraons surface or places subject to shock (ignorance can cause equipment damage).
- Please make sure that the power has been disconnected before you wire, install or dismantle the device.
- If smoke, odors or noise rise from the device, turn off the power at once and unplug the power cable, and then please contact the service
center.
- Do not drop the device or subject it to physical shock, and do not expose it to high electromagnesm radiaon. Avoid the equipment
installaon on vibraons surface or places subject to shock (ignorance can cause equipment damage).
- Do not place the device in extremely hot (refer to the specificaon of the device for the detailed operaon temperature), cold, dusty or
damp locaons, and do not expose it to high electromagnec radiaon.
- The device for indoor use shall be kept from rain and moisture.
Exposing the equipment to direct sun light, low venlaon or heat source such as heater or radiator is forbidden (ignorance can cause fire
danger).
- Do not aim the device at the sun or extra bright places. A blooming or smear may occur otherwise (which is not a malfuncon however), and
affecng the endurance of sensor at the same me.
- Improper use or replacement of the baery may result in hazard of explosion. Replace with the same or equivalent type only. Dispose of
used baeries according to the instrucons provided by the baery manufacturer.
- Do not expose the device to the corrosive gas. Otherwise the equipment damage may occur.
- Do not expose the device to the explosive situaon.
5
Hangzhou Hikvision Digital Technology CO.,Ltd. No.555 Qianmo Road, Binjiang District, Hangzhou 310052, China
Model DS-PDMC-EG2-WB/WE
Detecon Performance
Detecon Method Opening Contact
Detecon Gap 43mm Max
Feature
Digital Processing Support
Tamper Protecon Front,Rear
Environment Temperature Indicator Support
Signal Strength Indicator Support
Interface
Alarm Input Normally Closed,Normally Open,Impulse Count
Power Switch Power Up Enrolling
LED Indicator Blue (Alarm)
Transmission
Transmission Technology Tri-X Wireless
Transmission Method Two-Way RF Wireless
Transmission Frequency 433/868MHz
Transmission Security AES-128 Encrypon
Transmission Range(Free Space) 1.2Km(433MHz)/ 1.6Km(868MHz)
Frequency Hopping Support
Enrolling Method Power up,Remote ID,QR Code
Electrical Characteriscs
Power Supply Baery Powered
Baery Type CR123A x 1 (included), 3V/1600mAh
Typical Voltage 3V
Consumpon
Max. current: 41.57 mA
Quiescent current: 27.5μA
Low Baery Level 2.45 V
Standard Baery Life 5 Years
General
Operaon Temperature -10 °C to 55 °C (14 °F to 131 °F)
Storage Temperature -20 °C to 60 °C (-4 °F to 140 °F)
Operaon Humidity 10% to 90%
Dimension(WxHxD)
22.5mm × 103mm × 23.2mm
13mm × 34.4mm × 11.4mm
Weight 59g
Applicaon Scenario Indoor