User Manual

12.12 Synchronize Time
Synchronize the device me when it is inconsistent with the actual me.
Steps
1. Go to
Conguraon → System → System Sengs → Time Sengs .
2. Select Time Zone according to the device
locaon.
3. Select the me synchronizaon mode.
-
If an NTP server is available, select NTP and enter NTP server informaon to synchronize the
device me with that of the NTP server.
-
Select Manual Time Sync. and set me to customize the device me.
-
Select Manual Time Sync. and check Sync. with computer me to synchronize the device
me with that of the computer.
4. Click Save.
12.13
Congure DST
If the region where the device is located adopts Daylight Saving Time (DST), you can set this
funcon.
Steps
1. Go to
Conguraon → System → System Sengs → DST .
2. Check Enable DST.
3. Set Start Time, End Time, and DST Bias.
4. Click Save.
12.14
Congure Local Output
When the operaon menu cannot be displayed on the monitor due to that the main and auxiliary
interfaces have switched or the output resoluon does not match with the actual display, you can
switch between the main and auxiliary interfaces via the web browser.
Go to
Conguraon → System → System Sengs → Menu Output , and select Menu Output and
VGA
Resoluon.
Note
The funcon varies with device models. The actual device prevails.
12.15 Congure RS-232
Set RS-232 parameters if you need to debug the device via RS-232 serial port, or peripheral devices
have been connected.
Mobile Video Recorder User Manual
62