User Manual
Table Of Contents
- Legal Information
- Regulatory Information
- Symbol Conventions
- Safety Instruction
- Chapter 1 Product Introduction
- Chapter 2 Start up Device
- Chapter 3 Basic Operation
- Chapter 4 Network
- Chapter 5 Live View and Configuration
- Chapter 6 Mobile Device Features
- Chapter 7 Camera Management
- Chapter 8 Driving Behavior Analysis
- Chapter 9 Smart Configuration
- Chapter 10 Events and Alarms
- Chapter 11 Security
- Chapter 12 Maintenance
- 12.1 View System Information
- 12.2 Search Log File
- 12.3 Upgrade System
- 12.4 Configure Image Partition
- 12.5 Configure Overwritten Recording
- 12.6 Print Log
- 12.7 Enable IP Camera Plug and Play
- 12.8 Reboot
- 12.9 Restore Default Settings
- 12.10 Export Configuration File
- 12.11 Import Configuration File
- 12.12 Synchronize Time
- 12.13 Configure DST
- 12.14 Configure Local Output
- 12.15 Configure RS-232
- 12.16 Detect HDD
- 12.17 Configure Analog Camera
- Chapter 13 Local Menu Operation
- Appendix A. Communication Matrix and Device Command
Chapter 9 Smart Conguraon
You can enable license plate recognion and face picture comparison.
Note
The channel to enable the license plate recognion cannot be the same with the channel to enable
face picture comparison.
9.1 License Plate Recognion
9.1.1 Enable License Plate Recognion
You can enable license plate recognion (LPR) and set the LPR region. When a vehicle appears in
the LPR region and the license plate is recognized, a picture will be captured and the license plate
informaon will be overlaid on the captured picture.
Steps
Note
Up to two channels are supported for license plate recognion simultaneously.
1. Go to Conguraon → VCA → License Plate Recognion → License Plate Recognion .
2. Select Channel No.
3. Check Enable to enable LPR.
4. If the default LPR region and trigger line do not applicable to the actual scene, adjust the region
or line.
1) Place the cursor on the four corners of the region or the two ends of the line, hold the
le
buon of the mouse to adjust its size.
2) Select the region or line, and drag to adjust its
posion.
Note
You can lick Clear to clear the default region and line, and click Reset to generate the default
region and line, and then adjust its size or posion.
Mobile Video Recorder User Manual
42