User Manual

Figure 6-2 Congure G-Sensor
2. Select module according to actual situaon.
External
The G-sensor is connected to the device via RS-232/RS-485 interface.
Built-in
The G-sensor is a built-in module of the device.
3. Set the limit value for acceleraon alarm in X, Y, and Z direcons.
Note
X, Y, and Z represent the direcons of acceleraon and the unit of alarm value is G (G=9.8 m/s
2
).
During driving, the device will alarm when acceleraon of any direcon exceeds the set value.
4. Oponal: Set vehicle detecon if you want to detect sharp curve, collision, turnover, etc. and
trigger alarm when these behaviors are detected.
1) Check Vehicle
Detecon.
2) Check the detecon(s) according to the actual needs.
3) Enter
duraon and threshold for the detecon(s).
When the vehicle moving exceeds the set threshold, and the detected behavior duraon
exceeds the set duraon, alarm and record will be triggered.
5. Select the axis indicang the driving direcon according to the diagram.
6. Check the linkage acons for acceleraon alarm, including Audible Warning and Trigger Alarm
Output.
7. Click Save.
Mobile Video Recorder User Manual
32