User Manual

4.3 Network Sharing
4.3.1 Share Network via Wi-Fi AP
The recorder can work as a wireless router. Other devices can access network via the recorder.
Steps
Cauon
Wi-Fi AP and Wi-Fi cannot be enabled at the same me. Enabling one will disable the other
automacally.
1. Go to Conguraon → Network → Advanced Sengs → Wi-Fi AP .
2. Check Enable Wi-Fi AP, Enable AP Broadcast, and Enable WLAN HotSpot according to your
needs.
3.
Congure the hotspot parameters.
1) Enter SSID (hotspot name).
2) Select Security Mode.
3) Enter IP Address and SubNet Mask.
Note
The IP address should be in dierent network segment with that of TCP/IP address.
4. Oponal: Check Enable DHCP and enter Start IP Address and End IP Address.
5. Click Save.
Result
When the recorder connects to the network via dialing, the connected peripheral device can get
access to the network either.
4.3.2 Share Network via Cable
Connect a peripheral device to your recorder with a network cable. The peripheral device can
access the network aer the recorder is successfully dialed to the network.
Before You Start
Congure the IP address, gateway, etc. of the peripheral device.
Steps
1. Go to Conguraon → Network → Basic Sengs → TCP/IP .
2. Click Lan.
3. Check Enable Network Share.
4.
Congure the network parameters for the peripheral device.
Mobile Video Recorder User Manual
22