User Manual
Table Of Contents
- Legal Information
- Regulatory Information
- Symbol Conventions
- Safety Instruction
- Chapter 1 Product Introduction
- Chapter 2 Start up Device
- Chapter 3 Basic Operation
- Chapter 4 Network
- Chapter 5 Live View and Configuration
- Chapter 6 Mobile Device Features
- Chapter 7 Camera Management
- Chapter 8 Driving Behavior Analysis
- Chapter 9 Smart Configuration
- Chapter 10 Events and Alarms
- Chapter 11 Security
- Chapter 12 Maintenance
- 12.1 View System Information
- 12.2 Search Log File
- 12.3 Upgrade System
- 12.4 Configure Image Partition
- 12.5 Configure Overwritten Recording
- 12.6 Print Log
- 12.7 Enable IP Camera Plug and Play
- 12.8 Reboot
- 12.9 Restore Default Settings
- 12.10 Export Configuration File
- 12.11 Import Configuration File
- 12.12 Synchronize Time
- 12.13 Configure DST
- 12.14 Configure Local Output
- 12.15 Configure RS-232
- 12.16 Detect HDD
- 12.17 Configure Analog Camera
- Chapter 13 Local Menu Operation
- Appendix A. Communication Matrix and Device Command
Steps
1. Go to
Conguraon → Network → Advanced Sengs → Plaorm Access .
2. Check Enable.
3. Select
Plaorm Access Mode as Ehome Plaorm.
Figure 4-4 Connect to ISUP Plaorm
4. Select Plaorm Version.
5. Select Server Address Type.
-
When the server is in extranet, and the IP address is dynamic, you can select Domain Name.
-
When the server IP address is
stac, you can select IP Address.
6. Enter the parameters below.
Server Address
Enter the
stac IP address of ISUP plaorm.
Server Port
The default value is 7660.
Device ID
The ID of the device registered on the ISUP plaorm. If you leave it empty, you can log in to
the
plaorm with the serial No.
Mobile Video Recorder User Manual
20