User Manual

Note
If you want to enable DHCP, the network that the device is connected to should support
DHCP (Dynamic Host Conguraon Protocol).
-
Uncheck DHCP, and edit the IPv4 parameters.
4. Click Save.
5. Go to
Conguraon → Network → Advanced Sengs → Wi-Fi to set Wi-Fi parameters.
1) Click Wi-Fi Conguraon.
2) Check Enable Wi-Fi.
3) Click Search to search available Wi-Fi.
4) Select a Wi-Fi in Wireless List.
The related
informaon will be matched automacally.
5) Select Network Mode as Managed.
6) Enter the Wi-Fi key.
6. Click Save.
7.
Oponal: Go to Conguraon → Network → Advanced Sengs → Wi-Fi and click Wi-Fi Status
to view Wi-Fi status.
Result
Aer the Wi-Fi is connected, you can get access to the device via the WLAN IP address in
Conguraon → Network → Basic Sengs → TCP/IP .
4.1.3
Congure Local Network
When the device is connected to the network via network cables, and the IP address needs to be
edited to get access to the network or connect the IP cameras, set the LAN parameters.
Steps
1. Go to Conguraon → Network → Basic Sengs → TCP/IP .
2. Click Lan.
Mobile Video Recorder User Manual
17