User Manual

Before You Start
If the device contains only one NIC, you can visit the added IP camera directly. If the device
contains dual NICs, you need to enable virtual host funcon before vising the added IP camera.
Go to
Conguraon → Network → Advanced Sengs → Other , and check Enable Virtual Host.
Steps
1. Go to
Conguraon → System → Camera Management → IP Camera .
2. You can visit, edit, or delete the added IP cameras.
-
Click the address of the added IP camera to get access to the camera according to the
prompt.
-
When the IP addresses conict, you can edit the IP camera informaon.
a. Check the IP camera to be edited.
b. Click Modify, and edit the camera
informaon.
c. Click OK.
-
Check IP camera(s) and click Delete to delete the added IP camera(s).
3.2 Record and Capture
To record the videos of the connected cameras, or capture the license plate pictures if you enable
license plate recognion, you need to install a storage media and format it, and congure the
recording schedule, or congure the FTP server to upload the pictures.
3.2.1 Format Storage Media
A newly installed storage media must be inialized before it can be used.
Before You Start
Install a storage media.
Steps
1. Go to Conguraon → Storage → Storage Management → HDD Management .
2. Check the storage media and click Format.
Result
Aer format, the storage media status should be Normal.
3.2.2
Congure FTP
Congure FTP parameters if you want to upload the captured license plate pictures to the FTP
server.
Before You Start
Congure the FTP server, and ensure the device can communicate normally with the server
Mobile Video Recorder User Manual
7