Quick Start Guide

The ID of the device registered on the eHome plaorm. If you leave it empty, device logs in
to the plaorm with serial No.
5. Click Save and reboot the device to
acvate the new sengs.
4.3 IP Camera Management
The chapter is only available for device supporng IP camera feature.
4.3.1 Acvate IP Camera
Before adding an IP camera, acvate it by seng a password.
Steps
1. Go to
Conguraon → System → Camera Management .
2. Select an inacve IP camera.
Note
We highly recommend you to create a strong password of your own choosing (using a minimum of
8 characters, including at least three kinds of following categories: upper case leers, lower case
leers, numbers, and special characters) in order to increase the security of your product. And we
recommend you reset your password regularly, especially in the high security system,
reseng the
password monthly or weekly can
beer protect your product.
1. Click Acvaon.
4. Enter New Password.
5. Conrm password.
6. Click OK.
4.3.2 Add IP Camera
You can add the acvated IP cameras.
Before You Start
Make sure the device and camera to add are in the same network segment.
Steps
1. Go to Conguraon → System → Camera Management .
2. Oponal: If the device and the camera are in dierent network segment, modify IP camera
address.
1) Check the IP camera and click Modify.
2) Enter IP Address and Password.
3) Click OK.
3. Select a camera and click Add.
Mobile Video Recorder Quick Start Guide
11