User's Manual

9
1. Open the cover of USB interface on one side of the
body camera.
2. Connect the body camera to the charger with the USB
data cable.
 When the body camera is being charged, LED 1 is solid
red. When it is fully charged, LED 1 is solid green.
 You can enable quick charging mode. In quick charging
mode, all the power consuming functions will be
disabled, including network, recording, positioning, etc.
2.4 Install Battery
When the body camera is in low battery, LED1 flashes in
red with high frequency. In this condition, charge it in
time or change the battery.
1. Slide the fastener on the rear panel of the body
camera to the left.
Fastener
Figure 2-4 Slide Fastener
2. Open the back cover by pulling the protruding
handles.
Protruding
Handles
Figure 2-5 Open Back Cover
3. Take the battery out by pulling the battery handle.
4. Change a battery.
5. Install the back cover.
6. Slide the fastener to the right to lock the back cover.
2.5 Install 4G MicroSIM Card
Install a 4G microSIM card on the body camera if you
want to connect to the network via 4G microSIM card.
Shut down the body camera before the installation.
This chapter is only applicable to the body camera
supporting 4G.
1. Open the back cover and take the battery out. Refer to
2.3 Charge Body Camera for details.
2. Open the sheet metal of the card slot, and put the
card into the slot with the metal side facing down.
3. Push the sheet metal forwards to lock the card.