User Manual
Table Of Contents
- Chapter1 Introduction
- Chapter 2 Startup and Shutdown
- Chapter 3 Basic Functions
- Chapter 4 Network Configuration
- Chapter 5 Camera Configuration
- Chapter 6 System Configuration
- 6.1 Set System Sound
- 6.2 Set Voice Prompt
- 6.3 Turn on/off LED
- 6.4 Set Auto-Lock Time
- 6.5 Set Language
- 6.6 Set IR Lights
- 6.7 Set Positioning
- 6.8 Set Satellite Time Synchronization
- 6.9 Set Quick Charging Mode
- 6.10 Set Overwriting
- 6.11 Set Password Verification
- 6.12 View Battery Information
- 6.13 View System Information
- Chapter 7 Body Camera Assistant
- Chapter 8 Troubleshooting
Body Camera User Manual
19
3.7.2 Set Video Tag After Recording
Step 1 Go to Main Menu > Playback > Video.
Step 2 Enter the file list.
Step 3 Select the file and hold
for 3 seconds to set tag for it. The file with tag is named in red.
Figure 3-5 Set Tag After Recording
Step 4 (Optional) Hold
for 3 seconds again to cancel the tag.
Setting tags for audios and pictures are similar with that of settings video tags after recording. You
can refer to the steps above.
3.8 Alarm
3.8.1 Auto Alarm
If memory is full, when you start recording, taping, capturing, or other functions consuming
storage, the message “Memory is full.” pops up on LCD, and the body camera sends out an
alarm audio. To save new files, you need to backup device first and clear memory.
If the body camera is in low power, the message “Low power.” pops up on LCD, the body
camera sends out an alarm audio, and LED 1 starts flashing.
3.8.2 Manual Alarm
Before you start
Connect the body camera to the platform.