User Manual
Table Of Contents
- Legal Information
- Regulatory Information
- Symbol Conventions
- Safety Instruction
- Chapter 1 Product Introduction
- Chapter 2 Startup and Main Menu
- Chapter 3 Storage, Playback, and Backup
- Chapter 4 Network Settings
- Chapter 5 System Settings
- Chapter 6 Alarm Settings
- Chapter 7 Maintenance
- Chapter 8 Operation via Body Camera Assistant
Safety Instrucon
Laws and Regulaons
Use of the product must be in strict compliance with the local laws and regulaons. Please shut
down the device in prohibited area.
Power Supply
• Use of the product must be in strict compliance with the local electrical safety regulaons.
• Use the power adapter provided by qualied manufacturer. Refer to the product specicaon for
detailed power requirements.
• It is recommended to provide independent power adapter for each device as adapter overload
may cause
over-heang or a re hazard.
• Make sure that the power has been disconnected before you wire, install, or disassemble the
device.
• DO NOT directly touch exposed contacts and components once the device is powered up to
avoid electric shock.
• DO NOT use damaged power supply devices (e.g., cable, power adapter, etc.) to avoid electric
shock,
re hazard, and explosion.
• DO NOT directly cut the power supply to shut down the device. Please shut down the device
normally and then unplug the power cord to avoid data loss.
• DO NOT block the power supply equipment to plug and unplug conveniently.
• Make sure the power supply has been disconnected if the power adapter is idle.
• Make sure the device is connected to the ground
rmly.
Transportaon, Use, and Storage
• To avoid heat accumulaon, good venlaon is required for a proper operang environment.
• Store the device in dry,
well-venlated, corrosive-gas-free, no direct sunlight, and no heang
source environment.
• Avoid
re, water, and explosive environment when using the device.
• Avoid lightning strike for device installaon. Install a lightning arrester if necessary.
• Keep the device away from
magnec interference.
• Avoid device installaon on vibratory surface or places, and avoid equipment installaon on
vibratory surface or places subject to shock (ignorance may cause device damage).
• DO NOT touch the heat
dissipaon component to avoid burns.
• DO NOT expose the device to extremely hot, cold, or humidity environments. For temperature
and humidity requirements, see device
specicaon.
• The device can only be safely used in the region below 2000 meters above the sea level.
Body Camera User Manual
vi