Quick Start Guide

3.2 Storage
The recorded video, taped audio, and captured picture will be
stored in the device.
3.2.1 Record
You can record video via the device.
Steps
1.
Press
(recording buon) to start record.
•
Press the recording buon in the sleeping mode. The screen
will not be woken up if the voice prompt is enabled, or the
LED indicators are enabled, or voice prompt and LED
indicators are enabled at the same
me. If only LED
indicators are enabled, LED 1 will ash in red in low
frequency. If only voice prompt is enabled, the device will
output voice prompt. If voice prompt and LED indicators are
enabled at the same
me, LED 1 will ash in red in low
frequency, while the device will output voice prompt.
•
Press the recording buon in the sleeping mode. The screen
will be woken up if the voice prompt or LED indicators are
not enabled either. The recording status icon changes to red
on the status bar,
indicang the device is recording.
•
Press the recording buon when the screen has been woken
up. The recording status icon changes to red on the status
bar,
indicang the device is recording.
2.
Press the recording
buon again to stop recording.
3.
Oponal: Select Playback on the main menu to view the
recorded video.
Note
•
If you want to record a period of me before recording
starts, select Camera Sengs → Pre-Record to set pre-
record.
•
If you want to record a period of me aer recording ends,
select Camera
Sengs → Post-Record to set post-record.
3.2.2 Tape
You can tape audio via the device.
Steps
1.
Press
(taping buon).
The white taping icon appears in the lower center of the live
view page,
indicang the device is taping.
2.
Press the taping buon again to stop taping.
The white taping icon disappears, indicang the taping stops.
3.
Oponal: Select Playback on the main menu to view the taped
audio.
3.2.3 Capture
You can capture picture via the device.
Steps
1.
Press
(capture buon).
The device captures a picture.
7