User Manual
Table Of Contents
- Chapter 1 Panel Introduction
- Chapter 2 Installation and Connections
- Chapter 3 Start Up Device
- Chapter 4 Network
- Chapter 5 IP Camera
- Chapter 6 Camera Management
- Chapter 7 Live View
- Chapter 8 Storage
- Chapter 9 Playback
- Chapter 10 Platform
- Chapter 11 Backup
- Chapter 12 Events and Alarms
- 12.1 Configure Motion Detection Alarm
- 12.2 Configure Alarm Input
- 12.3 Configure Alarm Output
- 12.4 Configure Alarm Terminal
- 12.5 Configure Video Loss Alarm
- 12.6 Configure Video Tampering Alarm
- 12.7 Configure Video Quality Diagnostics
- 12.8 Configure Exception Alarm
- 12.9 Configure Satellite Positioning
- 12.10 Configure G-Sensor Alarm
- 12.11 Configure Arming Schedule and Linkage Actions
- 12.12 Configure Detection Area
- Chapter 13 User Account Management
- Chapter 14 General System Configuration
- Chapter 15 Maintenance
- Chapter 16 Shut Down Device
- Chapter 17 Appendix
Mobile Digital Video Recorder User Manual
68
Device No.: Edit the device No. for remote control. The device No. ranges from 1 to 255.
The default device No. is 255.
It is not recommended to modify Device No. Otherwise, you need to enter the Device No.
on the remote control every time you use it.
CVBS Brightness: Adjust video output brightness.
Menu Transparency: The transparency proportion of the menu displayed on the live
view interface. You can set it as 1:3, 1:1, 3:1, or Non-transparent. The smaller the
proportion value is, the more transparent the menu is. When Non-transparent is
selected, only the menu is displayed on the page.
Operation Timeout: If no operation is performed after a specified period of time, live
view will be displayed automatically.
Enable Touch Screen: Enable/disable touch screen. If the function is on, PTZ function is
unavailable.
Step 4 Click OK.