User Manual
Table Of Contents
- Chapter 1 Panel Introduction
- Chapter 2 Installation and Connections
- Chapter 3 Start Up Device
- Chapter 4 Network
- Chapter 5 IP Camera
- Chapter 6 Camera Management
- Chapter 7 Live View
- Chapter 8 Storage
- Chapter 9 Playback
- Chapter 10 Platform
- Chapter 11 Backup
- Chapter 12 Events and Alarms
- 12.1 Configure Motion Detection Alarm
- 12.2 Configure Alarm Input
- 12.3 Configure Alarm Output
- 12.4 Configure Alarm Terminal
- 12.5 Configure Video Loss Alarm
- 12.6 Configure Video Tampering Alarm
- 12.7 Configure Video Quality Diagnostics
- 12.8 Configure Exception Alarm
- 12.9 Configure Satellite Positioning
- 12.10 Configure G-Sensor Alarm
- 12.11 Configure Arming Schedule and Linkage Actions
- 12.12 Configure Detection Area
- Chapter 13 User Account Management
- Chapter 14 General System Configuration
- Chapter 15 Maintenance
- Chapter 16 Shut Down Device
- Chapter 17 Appendix
Mobile Digital Video Recorder User Manual
67
Figure 14-4 NTP Settings
Step 3 Check NTP to enable the function.
Step 4 Enter Synchronization Interval.
Step 5 Enter the IP address of NTP server.
Step 6 Click OK in NTP settings interface.
Step 7 Click OK in network settings interface.
14.4 Configure Advanced Display Settings
Purpose:
You can set the system time, select the CVBS output standard, enable the password,
configure the DST settings, etc.
Step 1 Go to Menu > Other Settings > Display.
Step 2 Click Set of Advanced Settings.
Figure 14-5 Advanced Settings
Step 3 Edit parameters as required.
Device Name: Enter the system name as desired.