User Manual
Table Of Contents
- Chapter 1 Panel Introduction
- Chapter 2 Installation and Connections
- Chapter 3 Start Up Device
- Chapter 4 Network
- Chapter 5 IP Camera
- Chapter 6 Camera Management
- Chapter 7 Live View
- Chapter 8 Storage
- Chapter 9 Playback
- Chapter 10 Platform
- Chapter 11 Backup
- Chapter 12 Events and Alarms
- 12.1 Configure Motion Detection Alarm
- 12.2 Configure Alarm Input
- 12.3 Configure Alarm Output
- 12.4 Configure Alarm Terminal
- 12.5 Configure Video Loss Alarm
- 12.6 Configure Video Tampering Alarm
- 12.7 Configure Video Quality Diagnostics
- 12.8 Configure Exception Alarm
- 12.9 Configure Satellite Positioning
- 12.10 Configure G-Sensor Alarm
- 12.11 Configure Arming Schedule and Linkage Actions
- 12.12 Configure Detection Area
- Chapter 13 User Account Management
- Chapter 14 General System Configuration
- Chapter 15 Maintenance
- Chapter 16 Shut Down Device
- Chapter 17 Appendix
Mobile Digital Video Recorder User Manual
43
Figure 8-4 S.M.A.R.T Information
8.2 Recording Settings
8.2.1 Configure Record Settings
Purpose:
Configure the transmission stream type, the resolution, frame rate, etc.
Step 1 Go to Menu > Basic Settings > Record.
Figure 8-5 Record Settings
Step 2 Select camera in Camera drop-down list.
Step 3 Configure the image parameters.
Encoding Parameters
Main Stream (Normal): Used for continuous recording.
Main Stream (Event): Used for event recording.
Sub Stream: Used for network transmission.
Stream Type
Video and Video & Audio are selectable.
Bitrate Type