User Manual

Unlock
Enter the unlock password and room No. on the door staon to open the
door.
Arm/Disarm
Create an arm/disarm password before conguring alarm parameters.
Arm or disarm the zone for the indoor staon by entering the arm/disarm
password.
Note
Arm/Disarm sengs page is hidden by default. Tap Sengs → →
Preference to enable Alarm, you can set the arm/disarm password.
Duress Code
When you are hijacked and forced to open the door, you can enter the
duress code. An alarm will be triggered to
nofy the management center
secretly.
Note
The duress code and the unlock password cannot be the same.
3.
Enter the old password.
4.
Create a new password and conrm it.
5.
Tap OK to save the sengs.
Note
Indoor Extension only supports admin password and arm/disarm password.
1.4 Synchronize Time
Steps
1.
Tap
Sengs → → Conguraon → Local Informaon → Sync Time to enter
the
me synchronizaon page.
Network Indoor
Staon Conguraon Guide
10