Quick Start Guide

2
1
DS-KH8350-(W)TE1
Network Indoor Staon UD20185B
1
2
3
4
5
7
8
6
Screen
1
Screen Microphone
2
Unlock Key
3
Loudspeaker
4
SD Card Slot
5
Debugging Port
6
Network Interface
7
Power/Alarm Terminal
8
Note: The appearance of the device varies according to different models. Refers to the actual device for
detailed informaon.
Terminal and Wiring
2
There are 20 pins in the terminal on the rear panel of the indoor staon: 2 RS-485 pins, 2
power pins, 2 alarm output pins, 8 alarm input pins, and 4 reserved pins.
Installaon
3
It supports wall mounng.
ENGLISH
Diagram References
Appearance
1
Installaon Accessory Descripon
The wall mounng plate is required when installing the indoor staon on the wall.
The dimension of wall mounng plate is shown.
Wall Mounng
Make sure the device in the package is in good condion and all the assembly parts
are included.
The power supply the indoor staon supports is 12 VDC. Please make sure your
power supply matches your indoor staon.
Make sure all related equipments are power-off during the installaon.
Check the product specificaon for the installaon environment.
Before You Start
1. Fix the wall mounng plate to the wall with supplied screws.
2. Put the indoor staon on the holder of the wall mounng plate.
Indoor Staon
5.5
95
95.6
15.3
4.6
60
42.1
Unit：mm
11
3
Scan the QR code to get the Operaon Guide
for detailed informaon.
Scan the QR code to get the Configuraon
Guide for detailed informaon.
Geng Started
4
You are required to acvate the device first by sengs a strong password before you
can use the device.
1. Power on the device. It will enter the acvaon page automacally.
2. Create a password and confirm it.
3. Tap OK to acvate the indoor staon.
Acvate Indoor Staon
1
Quick Configuraon
2
Refers to Video Intercom Network Indoor Staon Configuraon Guide (Scan the QR code) for details.
Refers to Video Intercom Network Indoor Staon Operaon Guide (Scan the QR code) for details.
Screw
Screw
Installaon Part Wall
1. Choose Language and tap Next.
2. Set network parameters and tap Next.
- Edit Local IP, Subnet Mask and Gateway parameters.
- Enable DHCP, the device will get network parameters automacally.
3. Configure the indoor staon parameters.
- .Select Indoor Staon and tap Next to link main door staon.
a. Edit Floor and Room No.
b. Create and confirm SIP register password.
Note: If you want to add the indoor staon to the door staon, the SIP password of the indoor staon
should be the same as the registraon password of the door staon.
c. Tap Advanced Sengs to edit Community No, Building No. and Unit No.
d. Oponal: Enable Indoor Staon Sengs and select the indoor staon to link.
- . Select Indoor Extension and tap Next to link indoor staon.
a. Edit No., Room Name.
b. Create and confirm SIP register password.
4. Linked related devices and tap Next. If the device and the indoor staon are in the
same LAN, the device will be displayed in the list. Tap the device or enter the serial No.
to link.
a. Tap the sengs icon to pop up the Network Sengs page.
b. Edit the network parameters of the door staon manually or enable DHCP to get
the network parameters automacally.
e. Tap OK to save the sengs.
5. Tap Finish to save the sengs.