Operation Manual
Table Of Contents
- 1 Overview
- 2 Appearance
- 3 Typical Application
- 4 Terminals and Interfaces
- 5 Installation and Wiring
- 6 Before You Start
- 7 Local Operation
- 8 Remote Operation via Batch Configuration Tool
- 9 Remote Operation via iVMS-4200
- 10 Accessing via Hik-Connect Mobile Client Software
- Appendix
Video Intercom Indoor Station·User Manual
30
Figure 9-12 Arming Mode Settings Interface
2. Press Outdoor Mode tab, Indoor Mode tab, Sleeping Mode tab, and Custom Mode
tab to enter corresponding arming mode settings interface.
3. Switch to to enable the arming in the selected zoon.
Zones in each arming mode can be configured manually. See detailed information in
7.3.4 Zone Settings.
For 24H alarm zone and smoke detector zone, even if it is disabled under current
arming mode, the indoor station will still alarm when it is triggered.
Arming mode settings should be configured with the settings of arming status on the
the user interface of the device.
The DS-KH6210-L and DS-KH6310-WL indoor stations only support 2 zones.
7.3.6 System Maintenance
Purpose:
You can format TF card, clear the screen, view the version information of the indoor
station and reboot the system on the system maintenance interface.
Steps:
1. Get to the system maintenance interface: Settings -> Maintenance.
2. Press the Format tab to format the TF card.
3. Switch to to enable the clear screen mode.