Configuration Manual

3.
Set the network parameters.
-
Enable DHCP, and the system can assign an IP address of the indoor staon
automacally.
-
Disable the DHCP funcon, and set the IP address manually. You should set
the device IP address, the gateway, the DNS address.
2.3.2 Set Linked Device IP
Linked network parameters refers to the network parameters of devices (like door
staon, doorphone, main staon, center, etc.), to which the indoor staon is linked.
Linked devices for the indoor
staon refers to door staon, center, main staon, and
doorphone.
With the private SIP protocol, intercom can be realized only when all these devices
are in the same network segment with the indoor staon.
With the standard SIP protocol, intercom can be realized when all these devices
support the standard SIP protocol.
Steps
Note
•
The doorphone does not support adding with the standard SIP protocol.
•
Here take door staon network sengs as example.
1.
Tap Sengs → → Conguraon , and enter admin (acvaon) password.
2.
Tap to enter the device management page.
3.
Tap Indoor Extension and select a connect indoor extension.
4.
Tap Main Door Staon to pop up the device informaon dialog.
Video Intercom Indoor
Staon Conguraon Guide
7