Operation Manual

Video Intercom Vandal-Resistant Door Station·User Manual
61
Weekday Template: The motion detection area is armed during the working time
period of each day. The working time period here is from 8 am to 8 pm.
4. (Optional) If you select Custom, you should manually set the time period. The way is
same with the settings of template 1.
Task 3: Set the Linkage Method for Motion Detection
Check the checkbox to select the linkage method. Send email, notify surveillance center,
and upload to FTP are selectable.
Figure 8-24 Linkage Method Settings
Notify Surveillance Center: Send an exception or alarm signal to remote
management software when an event occurs.
Email Linkage: Send an email with alarm information to a user or users when an
event occurs.
Note: To send the Email when an event occurs, please complete the Email
configuration in advance in Section 8.3.3.
Upload Picture to FTP: Capture the image when an alarm is triggered and upload
the picture to the configured FTP server.
Notes: Set the FTP address and the remote FTP server first. Please complete the
FTP configuration in advance in Section 8.3.3.
Working Mode
Click Video Intercom -> Work Mode to enter the working mode settings interface.
Figure 7-6 Working Mode Settings Interface
If you select the Intercom Mode, the door station functions as a video intercom device,
while if you select the IPC Mode, the door station functions as a camera only.
Supplement Light
Steps:
1. Click Video Intercom -> Supplement Light to enter the supplement light mode
settings interface.