User Manual

Table Of Contents

Unlink APP Account

Aer unlinking APP account, you cannot operate via APP.

Restore to Default Sengs

All parameters, except for the communicaon sengs, remotely imported user informaon, will

be restored to the default

sengs. The system will reboot to take eect.

Restore to Factory Sengs

All parameters will be restored to the factory sengs. The system will reboot to take eect.

Reboot

Reboot the device.

7.12 Video Intercom

Aer adding the device to the client soware, you can call the device from the client soware, call

the main staon from the device, call the client soware from the device, or call the indoor staon

from the device.

7.12.1 Call Client

Soware from Device

Steps

1. Get the client soware from the supplied disk or the ocial website, and install the soware

according to the prompts.

2. Run the client soware and the control panel of the soware pops up.

3. Click Device Management to enter the Device Management interface.

4. Add the device to the client

soware.

Note

For details about adding device, see Add Device.

5. Call the client soware.

1) Tap on the device inial page.

2) Enter 0 in the pop-up window.

3) Tap

to call the client soware.

6. Tap Answer on the pop-up page of the client soware and you can start two-way audio

between the device and the client

soware.

Note

If the device is added to mulple client sowares and when the device is calling the client

soware, only the rst client soware added the device will pop up the call receiving window.

DS-K5671-3XF Series Face Recognion Terminal User Manual