User Manual

7.10.2 Set Manual Aendance via Device
Set the aendance mode as manual, and you should select a status manually when you take
aendance.
Before You Start
Add at least one user, and set the user's authencaon mode. For details, see User Management.
Steps
1.
Tap T&A Status to enter the T&A Status page.
2. Set the Aendance Mode as Manual.
Figure 7-14 Manual Aendance Mode
3. Enable the Aendance Status Required.
4. Enable a group of
aendance status.
Note
The Aendance Property will not be changed.
5. Oponal: Select an status and change its name if required.
The name will be displayed on the T & A Status page and the authencaon result page.
Result
You should select an aendance status manually aer authencaon.
DS-K5671-3XF Series Face Recognion Terminal User Manual
49