User Manual

Steps
1. Click Access Control → Advanced
Funcon → Device Parameter to enter Parameter Sengs
page.
2. In the device list on the
le, select a lane controller and you can edit the lane controller's
parameters on the right.
3. Edit the parameters.
Passing Mode
Select the controller which will control the barrier status of the device.
• If you select According to Lane Controller's DIP
Sengs, the device will follow the lane
controller's DIP sengs to control the barrier. The sengs on the soware will be invalid.
• If you select According to Main Controller's
Sengs, the device will follow the sengs of
the soware to control the barrier. The DIP sengs of the lane controller will be invalid.
Free Passing Authencaon
If you enable this funcon, when both entrance and exit's barrier mode is Remain Open, the
pedestrians should
authencate each me passing through the lane. Or an alarm will be
triggered.
Opening/Closing Barrier Speed
Set the barrier's opening and closing speed. You can select from 1 to 10. The greater the
value, the faster the speed.
Note
The recommended value is 6.
Audible Prompt Duraon
Set how long the audio will last, which is played when an alarm is triggered .
Note
0 refers to the alarm audio will be played unl the alarm is ended.
Temperature Unit
Select the temperature unit that displayed in the device status.
4. Click OK.
9.7.2
Congure Device Parameters
Aer adding the access control device, you can set its parameters such as network parameters.
Set Parameters for Face
Recognion Terminal
For face recognion terminal, you can set its parameters including face picture database, QR code
authencaon, etc.
DS-K5671-3XF Series Face Recognion Terminal User Manual
115